AKA, Sounds like its filling up forever
AKA, Constant Rushing Sound
Tools and Materials Needed
- Adjustable wrench
- New flapper or chain (if necessary)
- Dry cloth, Sponge, Or Wet Vacuum
Step-by-Step Instructions
Step 1: Stop the Water Flow
Find the water shut-off valve located near the base of the toilet. Rotate it clockwise to halt the water supply, keeping your workspace dry during the repair. For a quarter turn valve, turn the valve so that the handle is going the opposite direction of the supply line
Step 2: Lift the Tank Cover
Gently remove the lid from the toilet tank and place it on a cloth to protect it from damage or slipping. (Side Aside in a safe space)
Step 3: Examine the Flapper
Check the flapper, the rubber seal at the tank’s bottom. If it’s not sitting flush or the chain is too short, it might stay open. Loosen the chain or swap out the flapper if it looks degraded.
Step 4: Adjust the Float
Look at the float, which regulates the water level. If it’s positioned too high, it could prevent the valve from closing. Carefully tweak the float arm downward or adjust its setting.
Step 5: Verify the Fix
Restore the water supply by turning the valve counterclockwise, then flush the toilet. Observe if the continuous flow has ceased. If not, the fill valve might require replacement.
Other Common Problems with Toilets!
Toilet Water line leak
- Old waterline.
- Degraded seals in the waterline.
- Not tightened to the toilet bowl or shut off properly.
Toilet leak from bottom of toilet.
- Possible clog in drainage system.
- The toilet was improperly set in place.
- Improper toilet seal
- If there is water on the floor around the toilet most likely it’s your tank that is dripping water somewhere. I’ve had this exact instance happen to me many times.
Missing Toilet Bolt Covers
- A white dome looking cap that covers the metal bolt that is on the left and right of the toilet on the floor. Usually it’s located close to the center.
- The covers prevent the bolts from corroding and give your toilet a clean look.
Stained Bowl
- This can be a sign that the water that is entering your home is dirty and or is full of hard minerals.
- Your Toilet is most likely old and because its porcelain over years and years of use the toilet takes on the color of the contents that sits inside.
- Something acidic was left inside the bowl.
Slow Flushing toilet
- Just an old model toilet.
- The toilet flapper needs to be replaced.
- Not enough water filling up in the tank.
- Partial clog in the drain system.
- The vent for the drain system is improper or is blocked.
When to Call a Professional
If the issue remains unresolved or you’re uncertain about the components, reach out to a plumbing expert. Brooky Plumbing is ready to assist with advanced fixes to keep your toilet in top shape.
For expert assistance with this or any plumbing concern, check out Brooky Plumbing at www.brookyplumbing.com or call us at [insert phone number]. We’re your reliable local plumbers in Asheville and Hendersonville, NC, available around the clock!